X

This site uses third parties to own and optimize your navigation and perform analytical work cookies. If you continue browsing, consider that you accept its use.
You can learn more at our Cookie Policy.


Return

E57188X - CSP075 Long-reach professional turbine sprayer 7,3 - 14 m. 3/4” Female Thread

NOZZLE INSTALLATION

1. Insert the plastic key end of the wrench into the lifting socket of the sprinkler and turn 90°. Pull the riser up to gain access to the nozzle socket

2. Using the hex key of the wrench, turn the radius adjustment screw counterclockwise to be sure it is not blocking the nozzle socket opening. If a nozzle is already installed, it can be removed by backing out the adjustment screw and turning on the water, or by pulling outward on the nozzle “ears” with a pair of needle- nosed pliers.

3. Slip the desired nozzle into the nozzle socket. Note that the socket is angled up 25°. The “ears” should be adjusted so that the nozzle range screw threads directly down between them. Then tighten the nozzle range screw. The raised bump with an arrow on the rubber cover will always indicate the location of the nozzle and direction of water flow when the sprinkler is retracted.

ALIGNING THE RIGHT (FIXED) SIDE OF ARC

In order to reset the right arc the body cap should be unscrewed counterclockwise and remove the internal assembly should be from the body. Once removed, rotate the nozzle turret to the right stop, screw the internal assembly back into the body with the nozzle aligned to the right side of the area you want irrigated.

ARC ADJUSTMENTS:
Adjustable heads are preset to approximately 180°.

- To Increase the Arc:

1. Insert the plastic key end of the wrench into the adjustment socket
2. While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360° turn of the wrench will increase the arc 90°.
3. Adjust to any arc between 50° and 360° (Fig. 5).
4. The wrench will stop turning, or there will be a ratcheting noise, when the maximum arc of 360° (full circle) has been reached.

- To Decrease the Arc:

1. Insert the plastic key end of the wrench into the adjustment socket
2. While holding the nozzle turret at the right stop, turn the wrench counterclockwise. Each full 360° turn of the wrench will decrease the arc 90°.
3. Adjust to any arc between 50° and 360°.
4. The wrench will stop turning, or there will be a ratcheting noise, when the minimum arc of 50° has been reached.

AUTO ARC Return
This E57188X sprinkler is designed with an internal device that re-aligns the arc if it is turned by vandals.

RADIUS / DISTANCE OF THROW

Insert the steel hex end of the wrench into the radius adjustment screw. Turn the screw clockwise (into the stream of water) to decrease the radius, or counterclockwise to increase the radius. Radius can be reduced up to 25%.

Reference: E57188X


Features

  • EAN Code: 8412081259468

Return